01 348 409 Fuel lines and parts

01.100 Gas lines: fuel pump to carb(s), small-block reproduction, complete sets with all fittings

These sets are bent in a jig and fixture like GM did 50+ years ago.

01.101 Gas lines: fuel pump to carb(s), 348 reproduction, complete sets with all fittings

01.102 Gas lines: fuel pump to carb(s), 409 reproduction, complete sets with all fittings

01.103 Gas lines: fuel pump to carb(s), custom (after market carbs, intake, or both), complete with all fittings

01.105 Gas lines: individual lines with all fittings

01.140 Gas lines: frame (tank to fuel pump), stainless steel

01.140 Gas lines: frame (tank to fuel pump), tinned steel

01.150 Hoses (gas hose with GM logo)

01.160 Sending units

01.170 Gas tank strainers

01.185 Custom gas tanks

01.200 Gas tank straps and hardware

01.400 Carburetor rebuild kits

01.450 Intake manifolds

Note: Center to center carb spacing on Offenhauser 2x4 intakes vary from 7-5/8" to 7-3/4". (GM and Edelbrock spacing is 6-7/16".) When ordering an air cleaner for Offenhauser, make sure you measure your intake.

01.500 Carter/Edelbrock carburetors

Note: Edelbrock carburetors are not modified for 348/409 original type fuel lines and linkage. To add modifications, add 1 #7579 for each carburetor ordered.

01.500 Rochester carburetors

Carbs are Rochester 2G's rebuilt to run as a 3x2 set. They are Dyno Tested. The front and rear carbs do not have an idle mixture circuit. The center carb has the idle mixture circuit that provides the fuel/air mixture for all conditions from idle to wide open throttle.

01.510 Carburetor hardware

01.700 Carburetor linkage

01.850 Fuel pumps

01.900 Fuel injection